2024-09-04
Reliability testing of automotive connectors generally touches on the following items: insertion and extraction force testing, durability testing, insulation resistance testing, voltage testing, oscil...
2024-09-04
The first generation of automotive connectors (Figure 1), started in 2008 or so, mainly from the industrial connectors at the time of the re-modeling. The characteristics of this generation of product...
2024-09-04
Terminal suppliers on this test and crimp the selection of the most basic responsibility, but also has the responsibility to provide specific crimp information, so that the wire assembly supplier spec...
2024-09-04
Mechanical life of durability: to a plug and a pull out for a cycle, to the rules of plugging and unplugging cycle after the connector can be normal end of its coupling function (such as touch resista...
2024-09-04
Common mode noise is generated by illogical planning. Some typical causes are different lengths of individual wires in different pairs, or different distances to the power plane or chassis. Another ca...
2024-09-04
Good insulated terminals should first have good workmanship, visual inspection can not be passed basically do not waste time and then electrical testing. So, what kind of terminal is considered good w...
2024-09-04
Outer diameter becomes smaller, brewing resistance exceeds the standard, you should let the workers stop, test is because the monofilament diameter is small, or equipment brewing, because the first pi...
2024-09-04
Terminals pressed after the need to wear rubber shell, this step can not be automated production, only manual, but also need to compare the first piece of the production line employees should be train...
2024-09-04
Poor line contact, the fault occurs in the plug. When the fault occurs, it will cause the electrical equipment can not work properly. Judgment, turn on the power supply of the electrical equipment, to...
2024-09-04
Automotive wiring harness in the use of a long time, there will occasionally be a short circuit or burned phenomenon, this situation needs to be dealt with immediately, especially burned, because the ...
2024-09-04
As the requirements of industrial applications nowadays continue to increase, the requirements for wiring are gradually approaching the limit level of electronic wiring harnesses, so the accuracy of t...
2024-09-04
The principle of the protective layer of the electronic wire combined the above two factors, take these two scales and consistent conductor protective layer thickness is appropriate. With reference to...
2024-09-04
With the increasing requirements of the use of intelligent equipment, their requirements for electronic wiring harness wiring is also gradually tend to a higher level, so the accuracy of the test equi...
2024-09-04
Terminal line can be very popular in the market now, electronic wire, toy wire is because the product in the actual use of the process with the role of the very obvious, many people are not clear in t...
2024-09-04
In the processing of terminal wire, the selection of raw materials will directly affect the quality of the product, so this link is very important, a finished wire harness is composed of wire, insulat...
2024-09-04
The technical indicators of automotive connectors mainly include mechanical, electrical and environmental impact resistance and other characteristics. Mechanical characteristics mainly refers to the i...
2024-09-04
As the plating film on the outside of the terminal is very much determined by the product itself on the life of one of the factors, we are in the use of such a product is very necessary to make it mor...
2024-09-04
According to the distribution of the electrical parts of each subsystem, determine the wiring form of the wiring harness, each wiring harness connected to the electrical parts and the direction of the...
2024-09-04
More and more environmental requirements of high-voltage cable products must be done to achieve a small outer diameter, in the process of laying needs to be considered to leave a gap, so as to dissipa...
2024-09-04
For the inspection of the wire need to use the multimeter resistance block to measure the resistance of the wire. Specific methods of operation are as follows: first of all, the measured wire is disco...
